Backbone Cables
In a SeaTalkng installation, a backbone cable runs through the length of the boat.
Individual devices connect to the backbone by spur cables that run to T-pieces on the backbone. The backbone carries both data and power to attached devices. The backbone should be sized so that it will run past every location where an NG or NMEA 2000 device might be installed.
Two backbone cable lengths can be joined together by part A06030, a backbone extender.
| Weight | 0.55 g |
|---|---|
| Dimensions | 8 × 8 × 1 cm |
Brand
Raymarine
No accessories available for this product.
No literature available for this product.
No videos available for this product.
Related products
Marine Navigation & Instruments > NMEA Cables & Sensors
NMEA Cable, 1 x 7 Pin Connector, 5 MetersReplaces Furuno Part # 000-144-418 WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
Marine Navigation & Instruments > NMEA Cables & Sensors
Micro Field-Attachable Connector Field-attachable connectors allows you to make field connections to bulk cable. The color-coded screw terminals match the individual wire colors found within the bulk cable for error-free field installation. Color-coded screw terminals make for error-free field installation Rugged housing material designed to withstand harsh marine environments
Marine Navigation & Instruments > NMEA Cables & Sensors
Micro Bulkhead Feed-Thru The Bulkhead Feed-Thru allows ease of installation through panels or bulkheads and establishes future connection points in a network installation. The bulkhead feed-thru also maintains the integrity of watertight bulkheads by providing a waterproof seal and connection Features rugged keyways for positive alignment of connections Waterproof rated to IP67
Marine Navigation & Instruments > NMEA Cables & Sensors
Micro Inline Termination Resistor The inline terminator is used where the NMEA 2000® network is terminated at a product, for example the top of the mast at a weather instrument or GPS antenna/receiver. The inline terminator plugs directly into the product with the other end connected to the network cable Micro Termination resistors usually terminate [...]
Marine Navigation & Instruments > NMEA Cables & Sensors
Micro Cap – Used to Cover Male Connector Micro cap used to cover male connectors.
Marine Navigation & Instruments > NMEA Cables & Sensors
Micro Tee A Tee is used to tap into the trunk line for adding a drop connection. The standard tee is also available with a cap for a protected diagnostic connection. Tees can be mated with all other devices on the network of the same connector style. Gold contacts for greatest reliability Keyed connectors for [...]
Marine Navigation & Instruments > NMEA Cables & Sensors
T-Connector For use with red NMEA network
Marine Navigation & Instruments > NMEA Cables & Sensors
Micro Field-Attachable Connector Field-attachable connectors allows you to make field connections to bulk cable. The color-coded screw terminals match the individual wire colors found within the bulk cable for error-free field installation. Color-coded screw terminals make for error-free field installation Rugged housing material designed to withstand harsh marine environments