NP-12 Nav-Pac – 12V
Marine communication and navigation electronics such as programmable data transceivers, GPS, and other microprocessor-controlled devices require clean and steady DC input power. Their sensitive circuitry is highly vulnerable to voltage drops from engine starts, noise and line spikes from alternators and motors, and noise from various other electronic devices. NAV-PAC prevents these conditions from affecting electronics.
Features:
- Prevents voltage “drop-out” during engine start and/or other high intermittent loads such as Thrusters
- Absorbs line “spikes”
- Filters out electrical interference
- Provides supplemental voltage and battery backup for up to 15 min.
- Optional remote panel (773-5037-0)
Specifications:
- Output: 12 Volt @ 20 amps max.
- Battery: Sealed Rechargeable 5.0 Amp-Hour, 5-7 years of typical life, can be replaced. A low-voltage disconnect circuit protects the battery from total discharge. Certified by DOT and IATA for shipment by air.
- Noise Filtering: Audio through 200 MHZ
- Voltage Spike Protection: Transient energy capability; 100 Joules, 4,000 amps Max (8 x 20 microseconds)
- Back-Up Power: 8A for 15 minutes, 12A for 8 minutes, 18A for 2 minutes, and 20A for 1 minutes
- Size: 5.25 x 6.2 x 7.4 inches (13.3 X 15.7 X 18.8 cm)
- Weight: 5.9 lbs. (2.7 kg)
This product may not be returned to the original point of purchase. Please contact the manufacturer directly with any issues or concerns.
| Weight | 7.6 g |
|---|---|
| Dimensions | 10 × 10 × 9 cm |
Brand
Newmar Power
No accessories available for this product.
No literature available for this product.
No videos available for this product.
Related products
Electrical > Battery Management
Battery Selector Switch Part No. 2111A Features New ergonomically styled turn knob provides easy On/Off switching Updated color scheme and graphics make it easier to determine switch status Longer stud lengths for improved assembly and easier cable routing Built with heavy-duty copper sweep contacts to ensure positive circuit control Rugged internal components protected by a [...]
Electrical > Battery Management
Blue Sea 6007 m-Series (Mini) Battery Switch Selector Four Position Red
6007m-Series (Mini) Battery Switch Selector Make before break contact design allows switching between battery banks without power interruption Selector Switches battery bank 1 or battery bank 2 or both to a single load using one switch Features: Ignition protected – Safe for installation aboard gasoline powered boats Case design allows surface, front panel, or rear [...]
Electrical > Battery Management
Diesel Power Battery Selector Switch Product Features Polycarbonate case For 6, 12, 24 or 36 Volt systems Alternator field disconnect (AFD) allowing selection of any position including “off”, without damage to alternator or electrical system One year warranty Specifications: Continuous Amps: 360 Momentary Amps: 600 Cable Lug Size: 1/2″ Color: Gray Dimensions: 5-1/2″ sq x [...]
Electrical > Battery Management
Cruiser Series Battery Selector Switch without AFD This battery switch can be used on 6, 12, 24 or 36V systems. Features: Polycarbonate case Surface mount Cable Lug Size: 3/8″ Dimensions: 5.50″ x 2.63″ WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, [...]
Electrical > Battery Management
9001e e-Series Battery Switch Selector Features: Make-before-break contact design allows switching between battery banks without power interruption CE Marked Ignition protected – Safe for installation aboard gasoline powered boats Case design allows surface or rear panel mounting Meets American Boat and Yacht Council (ABYC) requirements for battery switches 3/8″-16 tin-plated copper studs for maximum conductivity [...]
Electrical > Battery Management
Blue Sea 9002e e-Series Battery Switch Selector w/Alternator Field Disconnect
9002e e-Series Battery Switch Selector with Alternator Field Disconnect Features: Switches isolated battery banks to all loads or combines battery banks to all loads Includes AFD (Alternator Field Disconnect) Make-before-break contact design allows switching between battery banks without power interruption Ignition protected—safe for installation aboard gasoline powered boats Case design allows surface or rear panel [...]
Electrical > Battery Management
5510EDual Circuit Battery Switch CE Marked Ignition protected – Safe for installation aboard gasoline powered boats Case design allows surface or rear panel mounting Meets American Boat and Yacht Council (ABYC) requirements for battery switches 3/8" – 16 tin-plated copper studs for maximum conductivity and corrosion resistance, accepts 3/8" and M10 ring terminals 7/8" stud [...]
Electrical > Battery Management
6010m-Series (Mini) Battery Switch Dual Circuit™ Switches both positive and negative lines simultaneously with one simple ON/OFF switch meeting European and metal boat requirements for a double pole switch Switches circuits of different voltages, such as 12 volt and 24 volt, simultaneously with one simple ON/OFF switch Features: Ignition protected – Safe for installation aboard [...]