NAC-1 Autopilot Computer
The NAC-1 is the centre of your autopilot system, containing the electronics needed to operate and interface with other key components. It has been designed for hydraulic or cable-steered boats up to nine metres (30 feet) in length, and works with Simrad displays to provide a fully integrated autopilot solution.
Easy Installation
Plug-and-play connectors facilitate easy installation, minimising the wiring necessary to install your autopilot system. Industry-standard NMEA 2000® networking offers simple connectivity to heading sensors, rudder feedback units, and multifunction displays located anywhere on board.
Hydraulic & Cable Steer Options
The NAC-1 Autopilot Computer is recommended for boats up to 9 metres (30 feet) in length. It been designed to reliably drive either the Simrad PUMP-1 reversible hydraulic pump for hydraulic-steered outboards, or the HELM-1 drive unit for cable-steered vessels.
Virtual Rudder Feedback
Simrad Virtual Rudder Feedback technology eliminates the need to install a separate rudder feedback unit aboard outboard and sterndrive (inboard/outboard) boats with planing hulls. This reduces overall autopilot system cost and complexity, and is ideal where a feedback unit is impractical due to mechanical constraints.
Minimum Product Requirements:
A drive unit, heading sensor, NMEA 2000® network, and compatible autopilot controller or multifunction display are required to create a complete autopilot system. Some vessels may also require a rudder feedback unit.
Features:
- Reliable autopilot performance based on Continuum Steering technology
- Recommended for boats up to 9 metres (30 feet) in length
- Compatible with the Simrad PUMP-1 reversible hydraulic pump and HELM-1 cable steer drive unit
- Virtual rudder feedback for simplified installation aboard outboard and sterndrive boats
- Supports Simrad RF25 rudder feedback units
- Plug-and-play connectors for easy installation
- NMEA 2000® connectivity to heading sensors, rudder feedbacks, and multifunction displays
What's in the box?
- NAC-1 Course Computer
- NAC-1/NAC-2 Power Cable – 2m
| Weight | 2.6 g |
|---|---|
| Dimensions | 13 × 10 × 4 cm |
Brand
Simrad
No accessories available for this product.
No literature available for this product.
No videos available for this product.
Related products
Marine Navigation & Instruments > Autopilots
Furuno Rudder Reference f/Outboards On Navpilot 500 & 511 Autopilots
The FAPAR4502 is a Rudder Reference Unit for the NavPilot 500/OB and NavPilot 511/OB series autopilot. The FAPAR4502 has an 8″ maximum cylinder stroke. WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov. [...]
Marine Navigation & Instruments > Autopilots
Autopilot Pump, 12 VDC, 1.7 Cubic Inches Per Second (For Ram Sizes of 14 Cubic Inches to 25 Cubic Inches in Volume) The PUMPHRP17-12 is a reversing pumpset designed to interface the NavPilot series autopilot with a hydraulic steering system. The pump assembly incorporates a reversible gerotor gear pump, a two-piece gear housed in an [...]
Marine Navigation & Instruments > Autopilots
5M Extension Cable Garmin 5M (16.40 ft) extension cable for your GHP™ 10 is the perfect accessory for mounting the CCU further than 3M (9.84 ft) from the ECU. Compatible Devices:GHP™ 10 Marine Autopilot System WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth [...]
Marine Navigation & Instruments > Autopilots
LF3000 LF3000 is a linear feedback unit for boats with outboard engine. It transforms the linearmovement to an analog signal. Supplied with 8,5 m cable and mounting clamps. The LF3000 is a waterproof feedback unit. It has a 300 mm (11,8″) stroke and comes with a special mounting bracket which secures the LF3000 to the [...]
Marine Navigation & Instruments > Autopilots
Tiller Bracket The 120mm (4.72") Tiller Bracket is designed for use with Simrad autopilot computer systems.
Marine Navigation & Instruments > Autopilots
Type 2 Linear Drive – 12V Type 2 (short) Linear drive for mechancically steered vessels up to 33,000 lb(15,000kg). Designed for boats with existing mechanical steering systems. The mechanical linear drive provides powerful thrust, fast hardover times and quiet operation. Features: Low backdrive force, to minimize the drives effect on the boats steering when the [...]
Marine Navigation & Instruments > Autopilots
SP-80Fixed-Mount Autopilot SystemCruise Control at Sea. The SP-80 takes the helm and sets you free. For boater who know where they’re going. SP-80 takes you where you want to be–effortlessly. It’s smart, precise piloting gives you the extra hand on deck you’ve always needed. And the operation is a snap: Simply set the course and [...]
Marine Navigation & Instruments > Autopilots
Type 1 Linear Drive – 12V Linear drive for mechancically steered vessels up to 22,000lb (10,000kg). Designed for boats with existing mechanical steering systems. The mechanical linear drive provides powerful thrust, fast hardover times and quiet operation. Features: Low backdrive force, to minimize the drives effect on the boats steering when the autopilot is in [...]